Chapter 3 Tools required
- Razor blade or other very sharp knife
- Cutting board
- Lighter or propane torch
- Scissors
- Short wire fid (~150mm)
- Long wire fid (~850mm)
- Cyanoacrylate glue (preferrable thin)
- Cyanoacrylate accelerant (optional)
- Metric tape measure
- Sewing machine with a large needle and high-strength polyester thread, preferably V-46 Dabond 2000 UVR Polyester thread
- A modified presser foot with a 1mm-wide groove aligned with the needle.
- Rubber mallet
- Bench vise with wooden jaws or other means of bending 0.025 metal sheet
- Two strong spring clips
- 2mm long stick and some scrap line to place the flag line under tension
- Adjustable wrench for line stretching
- 5/32" drill bit